![]() Select the copper straight-through cable in the device selection box and attach it to the FastEthernet0 interface of the PC and the Gigabit Ethernet 1 interface of the wireless router. The PC will need a copper straight-through cable to connect to the wireless router.Using the device selection box, add the physical cabling between devices on the workspace. Step 3: Add the physical cabling between devices on the workspace Enter the new name of the newly added device into the Display Name field according to the Addressing Table.Click the Config tab in the device configuration window.To change the display names of the network devices, click the device icon on the Logical workspace.Step 2: Change display names of the nework devices. Cable Modem : Network Devices > WAN Emulation > Cable Modem. ![]() Laptop : End Devices > End Devices > Laptop.The category and sub-category associated with the device are listed below: Using the device selection box, add the devices to the workspace, add the following devices to the workspace. In this step, you will add a PC, laptop, and a cable modem to the Logical W orkspace. Step 1: Add network devices to the workspace. ![]() ![]() In this part, you will build a simple network by deploy ing and connecting the network devices. Part 2: Configure the End Devices and Verify Connectivity Instructions Part 1: Build a Simple Network In this activity, you will build a simple network in Packet Tracer. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |